[MUSIC] Greetings to all. In this class we will use and modify some models from the 3D warehouse. Here, we'll use the rectangle tool, rotate tool, and the scale tool. Let's get started. Now to do the front door, Double Click the wall to enter the wall group, and choose X-Ray style to add it more easily. We choose the Rectangle Tool, then we draw a rectangle according to the door's position. Then we'll input 200, 240, and select the X-ray style and push the rectangle backwards. Now we need a door, so we search for it on the 3D warehouse. Here we input door. According to the floor plan, we should find a double door and download it. Then we place this in the model. Rotate the door to the correct direction if needed. Then we choose the scale tool. Click the upper middle points and input 240 cm. If you input 240 without cm, the height will be 240 meters, because that is the scale selected for this model. Then click the side middle points and input 200 cm. Now we have a door with the correct size. Next, we use the move tool and move the door from the bottom left of the door and to move it to the hole. We can zoom in to do this precisely, like this. We finish placing the front door. Now to insert D4 Door. We double click the wall to enter the wall group and choose X-ray style for easier editing. Then we choose the Rectangle Tool to draw a rectangle according to the door's position. We input 210,90 and push the rectangle backwards. Rotate the model so that we can install another D4 door here. We draw a rectangle according to the door's position, and input 210,90. Push the rectangle backwards, again. We leave the group. From the Components window we find D4 door, and it places to the hole we just made. Now we choose a D4 again, places to the other hole. If the direction is wrong, change the selection points until the direction become correct. Then use move tool to move it to the right place. We install other D4 doors with the procedure After installing the D4 doors, we check the model, again. From the floor plan, we can see there's some of the door should open to the left. But the default door open to the right. We should correct this mistake. Select the door first and then choose the Scale Tool. Click side middle points, and input -1. Then move this to the right place. This approach is same as rotating it for 180 degrees. But instead of doing that, we prefer scale as -1, because it's easier to move it back to the right place. In this class, we learned to modify models from the 3D warehouse for our benefit. This is very convenient because the sketch of 3D warehouse is full of very detailed models. They can save a lot of time by just simply downloading and use it. Let's stop for now. Goodbye. [MUSIC]